build a rectifier

Adjudicado Publicado hace 7 años Pagado a la entrega
Adjudicado Pagado a la entrega

Hi IXYS

I would like to order parts for an electroplating rectifier but i'm still not sure of the design...I know little about electronics but figured the plating rectifier should be a breeze with your expertise.

Input voltage : 415 v 3 phase

Output voltage: 0-15 V

Output current: 0-1500 A

The ripple should be less than 5 percent. I'm not sure if i should go for a stepped setup or variable thyristor and then smooth it out. I had a look at component manufacturers and your products stand out. I know there will probably be a ton of extra specifications you will require which i will have to go and do some homework on. Basically what i'm concerned in is the ripple effect. Can you please advise me on what type of rectifier i should go for and design a cicuit?

Diseño de circuitos

Nº del proyecto: #10876919

Sobre el proyecto

4 propuestas Proyecto remoto Activo hace 7 años

4 freelancers están ofertando un promedio de R1597 por este trabajo

uetian09ee506

I am an Electrical Engineer having specialization in Electronics and Control, teaching in Electrical Department at FAST National University Pakistan. I am also persuing my MS degree in Electrical Engineering with speci Más

R1944 ZAR en 3 días
(75 comentarios)
5.8
seshupower

Hi, I am a post graduate power electronics engineer and having very good industrial experience of 8+ years in R&D and project development. I am excellent high frequency transformers design, circuits design, Regulated Más

R2222 ZAR en 3 días
(3 comentarios)
1.8
lamhai205

Please tell me what exactly you need, and i give you ideal and schematic if you want. Please contact me! s-k-y-p-e: h-a-i.l-a-m-2-0-5

R1111 ZAR en 3 días
(0 comentarios)
0.0
CyberSurgeon

i am electronic engineer in Pakistan. i have made many Power Supplies 3 phase to dc 12v, high current. i can design and or fabricate the power supplies here in Pakistan.

R1110 ZAR en 3 días
(0 comentarios)
0.0