ARDUINO Programmer
$30-250 USD
Pagado a la entrega
I need to move a 12v motor with a slider POT from a start point to an end point at a set speed using an Arduino Nano and a L293D H-bridge. 12 volt power supply for motor. Motor position is read using another slider POT. Start point, endpoint, and speed are adjusted using a battery of 6 push buttons.
Nº del proyecto: #8512234
Sobre el proyecto
37 freelancers están ofertando un promedio de $137 por este trabajo
hi I am an expert arduino programmer i can do it for you please contact me as soon as possible so that we can start this project I assure you quality work and on time delivery Please reply to discuss it further I Más
Hi, I hope you are doing well. I understood your project and I cna implement it as per your requirement. I can make a demo for you. Looking Forward, Khawaja
Hello Sir, I went through your project proposal and it's very interesting and I would like to work on this project. Why you should hire me ? * I have four year experience as a freelancer and Más
Hello, Have a Great Day. My name is Shahbaz Ali. I am running a setup for Prototyping of Electronic devices. We will deliver you a fully working schematics and arduino sketch. we will build the circuit in our lab Más
I have experience on Arduino. I have experience on VB.Net and MFC. I have experience in developing the MCU embedded system with C,C++ language with PIC, RENESAS, NEC.... I have designed the concrete plant control sy Más
Hello: I am interested in this project. Please send datasheet or model number of the 12V motor, if you consider. Thank you, Sam
Hello, project should take only a couple of hours to complete, as i have done this many times. I can provide code, schematics, etc
I am an Electrical Engineer having specialization in Electronics and Control, teaching in Electrical Department at FAST National University Pakistan. I am also continuing my MS degree in Electrical Engineering with spe Más
Hello! I am a novice engineer developer of electronic equipment. I have good experience with Arduino and AVR microcontrollers on Wiring language and clearly C. I dealt with the L293D bridge, L298N bridge and stepper m Más
Have you considered using a stepper motor? Message me if you're interested in my bid and I'll reply asap.
Hi I just completed a very similar project this week for a client. I could deliver you the code for this in a day or two. I am an electronics engineer based in the Philippines with over a decade experience in embedd Más
I'm electronic engineer and I'm experienced programmer of arduino. I read and understand the requirement. I can do the job. Thank you.