Initially I need a simple buffer/amplifier cct

Cerrado Publicado hace 7 años Pagado a la entrega
Cerrado Pagado a la entrega

For initial testing of a battery/power supply prototype we need a cct that allows us to take the signal from a function generator and feed those amplified signals into a variety of loads, resistive, capacitive and inductive. If we can have adjustment/limit on the output voltage (maximum 30 volts) and current (maximum 10 amps) it should allow us to feed into most any load? There is no need for a PCB layout, initially only a breadboard prototype is required.

Ingeniería eléctrica Electrónica

Nº del proyecto: #12511564

Sobre el proyecto

6 propuestas Proyecto remoto Activo hace 7 años

6 freelancers están ofertando un promedio de $266 por este trabajo

sahanwa23

Hi! Im an electrical and electronic masters graduate of UWE. I have the experience of programming in C/C++/Assembly/Arduino/PIC C/MikroC/MATLAB for more than three years. I also have the knowledge and experience of EL Más

$222 AUD en 3 días
(28 comentarios)
4.6
SantoshKGD

Hello, We have done similar project (PC based Power Supply Test Jig), using a PC and Micro-controller for testing and data logging of power supply units in various conditions(-40 to 60C operation, vibration, shock e Más

$444 AUD en 3 días
(5 comentarios)
4.0
shazemsaadHazem

Hello...I'm aerospace engineer have excellent experience with electronics...I can help you in this project and promise to give excellent results..

$222 AUD en 3 días
(4 comentarios)
2.5
weslyons

I will ship a working board that is soldered on a protoboard (similar to bread board but more stable and practical). I have a background in electrical engineering so I will produce a high quality product.

$155 AUD en 3 días
(0 comentarios)
0.0