Review and finalise the NFC RF PCB for FCC & CE Certification -- 4

Hello, I am an electronics and telecommunication engineer and my major is wireless systems' design. I am experienced in hardware and embedded systems' design. I have designed/printed/tested many PCBs and I am quite experienced with RF design such as designing antennas, matching networks(distributed/lumped elements), filters(distributed/lumped elements), power amplifiers, dividers, feed networks, differential pairs/signals, EMI, clearance areas, shielding for EMI, conducted interference, common mode, etc, LVD, high speed data communication. I have checked your requirements I am quite sure that I can help you with your project. Just give me all the details and I will do my best to help you. Best regards

Hello, I have 10+ years of Embedded HW product design with multiple domains like a consumer, industrial, automotive, IOT and wearable product. -Hardware architecture design using MCU, controller, and FPGA, as well as low power battery, operated device -Experience in all phases of product development from prototyping to mass production • TEAM building for a startup, leading a team of hardware, firmware, mechanical engineers-Expertise in hardware testing and troubleshooting/root cause -Working experience on power management system design with Buck-boost, Battery charger, and fuel gauge, USB3.0 Ctype and PD charging, POE and etc -Expertise in design and simulation of analog circuits -Experience in Microprocessor and microcontrollers like NXP, ST, Microchip, Marwell, Qualcomm, MediaTek, TI, Renesas, and Atmel -Exposure in mechanical design review -Expertise in wireless SOC with Bluetooth, WIFI, 4G, Lora, Zigbee from NXP, Nordic, Ublox, Qualcomm, Cypress, Broadcomm, TI, ESP, Silabs, Microchip -Experience in wire interface USB2/3, SPI, I2C, UART, HDMI, Ethernet, SDIO, MIPI-CSI/DSI, CAN, Modbus, RS232, RS485 -Expertise in solving problems of EMI/EMC -EMI / EMC compliance testing and product certification like CE/FCC/UL and etc Also, We have a team for software development, firmware development as well as CAD design. we will define milestone and adjust amount after discussion Let me know if you need help from me. Thanks. --Alpesh

Hi, I can definitively help you on this project. It‘s important to remind that it is a complex task and means it costs money. I have experience about GSM certification in partnership with Wawecom. I would be interested in getting your schematic if you don‘t mind. Best regards, Michel