I need source code of embedded software

$30-250 USD

Cerrado

Publicado

hace más de 5 años

$30-250 USD

Pagado a la entrega

I need reverse engineering support. I have an electronic card module and with software. Most of software parts are open source already but small parts are not. Software was designed on IAR 6.7 and module has STM32 and ARM Can you provide to open source part and edit/clean/revise codes and be ready to compiler the software for using?

Embedded Software

ID del proyecto: 18706369

Información sobre el proyecto

5 propuestas

Proyecto remoto

Activo hace 5 años

¿Buscas ganar dinero?

Dirección de email

Beneficios de presentar ofertas en Freelancer

Fija tu plazo y presupuesto

Cobra por tu trabajo

Describe tu propuesta

Es gratis registrarse y presentar ofertas en los trabajos

5 freelancers están ofertando un promedio de $173 USD por este trabajo

@fermatliu

Hello I am expert for C/asm programming. I do reverse before. Can you give more information about ur project？ Time & Fee should negotiate later, do U agree

$30 USD en 30 días

0,0

(0 comentarios)

0,0

@SimonZhang0212

I have ten years experience in embedded systems, good at using keil or IAR studio,. I think I can help you.

$277 USD en 8 días

0,0

(0 comentarios)

0,0

@hayat38402

I'm an electronic engineer with more than 15 years of work experience. I work as HW designer; FW and SW developer. As HW designer, I work in Altium, KiCad and Orcad and I have experience in development single MCU (Microchip PIC and ARM Cortex) boards with several digital I/O (GPIO, UART, SPI, I2C, PWM) and some analog I/O. I design complete board: power section, MCU section, peripheral section, I design also boards with battery power; so I have experience in low power PCB design. I have also experience in commercial boards (Arduino, Raspberry, Beaglebone ) shields design. I have also experience in bluetooth (both 2.0 and 4.0) PCB design.

$250 USD en 3 días