Looking to start off building a simple program based off real equipment but in a digital space. For this bid am only using one Image Pro, One Delay, 4 generic computers, 2 generic Projectors, 2 geberic monitors, 6 generic video cables, (HDMI - VGA - DVI - HDSDI - 5/Wire RGBHV - BNC . Example lets say you have a Mac book pro and all it specificics based solo on its I/O ( Input/Output). For the example it can only handle 1920x1080 & 1024x768. Then the geberic switcher we build only handle 1920x1080 & 1280x720. Now these two pieces of equipment are connected by a HDMI cable which only handle 1920x 2080 . In the virtual system I get all green light for this setup cause the cable the switcher and the computer can all run on the same resolution. Last we come out HDSDI which also handle 1920x1080 and that get plugged into projector one. Now projector one get a green light but when you loop out to projector two you get a red light. And above the projector your spec indicate that you do not have any HDCP capabilities, there for the weak link is the HDMI cable which has HDCP... These is a sample but very close to what I want to create for the software program. I incision that the Gui system will be two layers the first layer is the basic set up window where you input the switcher your using the projector the cables and monitors and so forth. Then the next window would be a 3D environment that allows you to space the gear out and attack cables to I/O... This second page will be development at a later time but the design is already created... Lastly the program needs to be able to evolve and grow with more gear has i fine tune the needs of the software and it needs to be a online program that can be
downloaded and ran with a key offline or online with a key which need to for each user.... The payment method I plan to be monthly or a one time fee and then a fee for updates