construction drawings for vacation house made of premade modules.

construction drawings for vacation house made of premade modules. the task is to create a building plan for a summer house. construction drawings must contain 3 parts. the three parts are the rules from the state. In addition, a fourth task to make a beautiful 3D image of the same building. the building will be constructed of 3 x modules. the outer walls of the modules are already available but can be changed. interior walls are also available, but can be changed. The three modules have dimensions of 3 m by 10 m. A total of 90 square meters. the layout can be changed by changing the positions of the three modules. the roof should have an angle of more than 10 degrees and less than 50 degrees. attached are examples of drawings of the 3 parts of the task. there are also sketches of the three modules. there's even a photo of a sketch of the layout of the building might look like. There are also several examples of what I think is a contemporary look at the holiday home. typical of modern uteseende's angular lines (not round), dark facade and large glass surfaces, which reaches down to the floor.   Part 1: floor plan: A floor plan is a horizontal section through the building. The floor plan should show: • Flat Planets different rooms. • Fixed furnishings (eg kitchen furniture, washing cabin, toilet and shower). • Windows and doors. • Dimensions of door openings (clear passage dimension). • Where sections are taken. • Construction surface (BYA) in square meters. The scale used is 1: 100. Think of... • The drawings must be to scale. In a scale of 1: 100 is 1 cm the drawing 1 m in reality. • Mark on the floor plan where the section is taken, for example, from point A to point A = Section A-A. • Availability requirements - In a house will entrance level at least have the room for hygiene (toilet / shower), sleeping / sleeping, cooking and dining space, space for seating and space for storage. These rules do not apply to homes with no more than two housing.   Part 2: Facade drawing Facade drawing must show: • Selection of facade materials. • Colours for each facade (can also be specified in application form). • Design of windows, doors and any division of the cladding. • The building's base. • Existing and new land routes to the property boundary. The scale used is 1: 100. Think of... • The drawings must be to scale. In a scale of 1: 100 is 1 cm the drawing 1 m in reality. • Set facing the cardinal points, such as the facade South. • If the ground changed, both existing land line (Dashed) as future land line (solid) Reported   Part 3: sectional drawing A sectional drawing is a vertical section through the building. Sectional drawing must show: • Roof pitch. • Total height. • Building Height. • Room height. • Ready-floor height (FG). • Roof and golvbjälklagens placement and any level differences. • Map Foundation. • Land Line. The scale used is 1: 100. Think of... • The drawings must be to scale. In a scale of 1: 100 is 1 cm the drawing 1 m in reality. • Mark on the floor plan where the section is taken, for example, from point A to point A = Section A-A. • Planning, façade and section drawings must agree together