I need a PCB layout for a PIR motion sensor activated LED strip. It is to powered using 3.3-4.2V 18650 batteries. I will need a suggestion for an easily sourced relay transistor and the supporting circuit for a low power and stable system. I would like to design for manufacture where possible utilizing SMD components when possible. Deliverable to be schematics and gerber files.
BOM-
(1)AS312 PIR Sensor Module
(1)HT7530-1 3V Regulator
(2) 2.00mm 2-pin JST connector
(1)2.00mm 3-pin JST connector
(1)Transistor Relay for switching LED power
Any supporting capacitors, resistors, etc. as necessary
Hi,
I have develope before power bank and it has 18650 batteries. I can add charging unit to your PCB and you can charge via mini/micro usb cable to 18650 batteries. Also I have experienced about other parts of the project too.
All the BEST,
Ali SERBETCI
Should be able to use a fet as a low side switch with almost no other components. An open drain comparator would allow hysteresis if needed. Need to get datasheet for PIR to optimize.
Should take about 3 hours, so really just one night to complete.
Hi
Hope you are doing well. Personally an Electrical Engineer (Specialization in Power) and leading a team, consists of MASTER experts from different fields. Our team is new on this website but we assure you best quality work which will be provided to you within your given deadline.